EQUIPMENT: ENVIRONMENTAL SYSTEMS

• THERMAL OXIDIZERS

• CATALYTIC OXIDIZERS

Catalytic Oxidizers

PRODUCT GROUP OVERVIEW

Customer Convenience
Stelter & Brinck catalytic oxidizers are complete with controls and offer the utmost convenience with prewired and prepiped assembly.

Stelter & Brinck catalytic oxidizers are designed to be easy to use and install, among the features offered are:

Control panel with annunciator, PID digital temperature control, FM approved high temp limit, flame safety relay, main power disconnect, and control transformer.
Remote control interface capability for use with PLC or DCS systems available.

Superior Performance
Stelter & Brinck catalytic oxidizers are a product of more than 40 years

of industrial combustion experience and feature:

EPA destruction efficiency compliance guaranteed.
Fully packaged and ready to install.
Oxidizer control system included.
Energy efficient design with primary heat recovery available.
Heavy-duty construction.

CFO-HX

Catalytic Fume Oxidizer with Heat Recovery
Applications of less than 20% LEL can benefit from our energy saving recuperative catalytic oxidizers. If you emissions stream is void of potential fouling agents or poisons, our catalytic units may be the perfect match. Catalytic units operate between 650°F and 750°F; resulting in lower fuel costs than thermal oxidizers when combined with our 50% to 72% effective heat exchangers.

Burner access door with OSHA railing
Test platforms available
Process fan with TEFC motor
CE ratings available
Emission inlet with purge air tee damper
Catalyst access door
Prewired
FM, NFPA, or IRI approved prepiped valve train
50-72% efficiency heat exchanger shell and tube manufactured by S&B

Oxidizer Application Data Sheet

CFO

Catalytic Fume Oxidizer without Heat Recovery-Direct
Applications of less than 20% LEL can benefit from our energy saving catalytic oxidizers. If your emissions stream is void of potential fouling agents or poisons, our catalytic units may be the perfect match. Catalytic units operate between 650°F and 750°F; resulting in lower operating costs then thermal oxidizers.

10 ga. steel construction, 316 SS inner liner
Flow control damper
Process fan with TEFC motor
Purge air damper and emission inlet
Skid mounted packaged units are prepiped, prewired and test fired prior to shipment
FM, NFPA, or IRI approved valve train
CE ratings available

Oxidizer Application Data Sheet