GENERAL INDUSTRIAL EQUIPMENT
OVERVIEW
Customer Convenience
Stelter & Brinck ovens and furnaces are designed to be easy to use and install, among the features are:
- Control panel with annunicator
- PID digital temperature control (single or multi-loop), FM approved high temperature limit, flame safety relay, main power disconnect, control transformer, and process blower motor starter
- Remote control interface capability for use with PLC or DCS systems available
- GAP (IRI) or NFPA construction standard
Superior Performance
Over 55 years of process heat and combustion experience ensures Stelter & Brinck customers that the furnace or specialty oven they purchase is of the highest quality. Our flexibility of design, attention to detail, and integrity mean that every furnace performs as promised.
PRODUCT GROUP OVERVIEW
Stelter & Brinck, Ltd. specialty ovens and furnaces are ideally suited for higher temperature operations or in environments that require extra heavy-duty construction not offered in traditional ovens.
Batch Stress Relieving Furnace
Castings are loaded by fork-lift in baskets. The furnace features side to side, recirculating flow at high rates to insure uniform heating of all parts. Controls provide both ramped heat-up, soak, and cool down.
Ring-Style Heat Treat Furnace
Steel rolls for use in steel rolling mills are heat treated in these unique ring style furnaces. The furnaces can be stacked up to 16 rings high to accommodate rolls of varying lengths while leaving the roll ends outside of the furnace.
Aluminum Sheet Coil Aging Oven
Aluminum aging oven for processing aluminum sheet in roll form. The unit included 5 heat and soak zones with extremely tight temperature uniformity. The integral conveyor handled 10 rolls simultaneously, up to 100,000 lbs. of aluminum sheet at once.
Specialty Tube Furnace to Cure Ceramic Coating on Small Diameter Pipe
A manufacturer of ceramic coated piping used in the aluminum industry required a continuous furnace to cure the coating on the pipe. This unique furnace allowed 8 parallel pipe lines to be cured. The furnace included complete controls including furnace pressure control.
Pit Annealing Furnace
Pit annealing furnace with lift off lid featured high velocity combustion system and castable refractory hearth. The furnace was shipped test fired and ready for installation.
Complete Combustion Assemblies/ Valve Trains/ Control Panels
Custom designed pre-piped, pre-wired packaged combustion systems can up-date your old equipment to modern standards of safety, performance, repeatability, and reliability.
COMMON APPLICATIONS
- Heat treating metals
- Aging aluminum
- Drying and curing refractory
FURNACE CONVERSIONS
Furnace conversions are also available. Convert your costly electric furnace to a more economical gas fired furnace. Not only can we provide the design, the combustion equipment, safety controls, and process controls; we can also provide installation of the new system.
Electric to Gas Conversion of Tilt-Style Heat Treat Furnace
Tilt-Style electric heat furnace (1600°F) was converted to radiant tube indirect gas firing, on site and on time. The conversion required that an exhaust system be installed and that the hydraulic and structural capabilities of the furnace be upgraded to handle the additional weight of the combustion system. The fuel cost savings paid for the conversion in less than one year.
|
